Free Cutting Dual Bend

Notice

1. Use a suitable power supply rated 20% higher than the product’s maximum power to ensure long-term performance.
2. Do not install while power is on. Before powering on, make sure the wiring is correct.
3. Do not modify or damage the circuit or any other component of the product.
4. Avoid scraping, twisting, and irregular bending during installation; these may cause non-repairable damage.
5. Minimum bending diameter: 200 mm (7.87 in.) for top-bend and 280 mm (11 in.) for side-bend. Smaller diameters may break the product.
6. Minimum twist angle: 360° per 1000 mm (39.4 in.) of length.
7. Excessive run length can cause overload or uneven brightness.
8. To protect your eyes, do not stare at the product for a long time while it’s illuminated.
9. Only professional personnel should install, dismantle, and repair.
10. See the bend-and-twist diagram below.